GoFit gftmg01 User Manual

- 7 -
ASSEMBLY STEPS
CAUTION!
ALWAYS ASSEMBLE THE TREADMILL
WITH AN ASSISTANT, DO NOT
ATTEMPT ASSEMBLY BY ONESELF.
STEP ONE
a) Insert the left console mast (without a
wire attached inside) into the base frame.
Attach the left console mast with four
M8x15mm bolts using the Allen wrench
(Do not tighten the bolts yet)
b) Put the lower console wire and
grounded wire inside and through the
right console mast using the wire
attached inside the right console mast.
Insert the console mast into the base
frame and secure with four M8x15mm
bolts using the Allen wrench
(Do not tighten the bolts yet)
STEP TWO
a) Connect the upper console wire to the
lower console wire. Connect the
grounded wires, assemble the console
set to the console masts. Attach with four
M8x15mm bolts using the Allen wrench
(Do not tighten the bolts yet)
*Caution*
Be careful when connecting the two
console wires. There are pins inside the
connector, the pins MUST be straight,
otherwise it will cause a problem.
STEP THREE
Secure the bolts from Step One & Two

GoFit gftmg01 Specifications

General

Brand	GoFit
Model	gftmg01
Category	Treadmill
Language	English