EN - 18
Install the batteries into the remote control.
• Open the battery compartment by sliding the cover back.
• Insert the new battery as pictured making you have observed the correct
polarity.
• Close the battery compartment.
Point the remote control at the remote control sensor on the front panel.
The remote control works with in a distance of about 8 meters from the sensor
and within an angle of about 30 degrees from the left and right side.
NOTE:
Remote the batteries when you don‘t intend to use the remote control for a long time.
Do not mix new and used batteries, or different types of batteries.
Weak batteries can leak and severely damage the remote control.
Be environmentally friendly and dispose of batteries according to your government regulations.
USAGE CONNECTION
OPTICAL digital audio input > OPt
Connect the Digital Optical Audio cable (not included) to the optical output on the audio source and to
the Optical Input on the soundbar.
Press the MODE button on the remote control to switch to Optical mode or press the MODE button
on the main unit repeatedly to select the Optical mode.
Using the remote control on your connected device, make sure the audio settings are set to PCM or
optical Audio and are turned On. Audio from the connected audio source will now be played through
the speakers.
• HDMI ARC (CEC) > ArC
Connect the ARC Audio cable (not included) to the ARC output on the audio source and to the ARC
Input on the soundbar.
Press the MODE button on the remote control to switch to ARC mode or press the MODE button on
the main unit repeatedly to select the ARC mode.
Using the remote control on your connected device, make sure the audio settings are set to ARC or
HDMI Audio and are turned on. Audio from the connected audio source will now be played through
the speakers.
HDMI CEC - This function allows to control the CEC-enabled devices, that are connected through
HDMI ports by using the remote control of the TV.
NOTE: If the TV is connected to the soundbar system with an HDMI or optical cable, the sound may
be delayed due to the audio processing delays in the soundbar.
To Next Page
Loading...