EasyManua.ls Logo

Gojo 8 Series User Manual

Gojo 8 Series
2 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Page #1 background imageLoading...
Page #1 background image
8 Series (ES8, CS8, CB8)
Activity
Monitoring
System
Transmitter Module Installation
Procedure
! Compliance Statement (FCC part 15.19):
This device complies with Part 15 of the FCC rules.
Operation is subject the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may cause undesired
operation.
! Caution (Pertaining to FCC part 15.21):
Modifications to this equipment not expressly approved by GOJO Industries, Inc. could void the user's authority
to operate the equipment.
! Compliance Statement/Déclaration de Conformité (IC):
This device complies with Industry Canada’s license-exempt RSSs. Operation is subject to the following two
conditions:
(1) This device may not cause interference; and
(2) This device must accept any interference, including interference that may cause undesired operation
of the device.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de
licence. L'exploitation est autorisée aux deux conditions suivantes:
(1) L'appareil ne doit pas produire de brouillage, et
(2) L'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est
susceptible d'en compromettre le fonctionnement.
This unit is certified to FCC Part 15 Part C for intentional unlicensed radiators.
FCC ID: 076-T6SG0910A
IC: 10391B- T6SG0910A
Question and Answer IconNeed help?

Do you have a question about the Gojo 8 Series and is the answer not in the manual?

Gojo 8 Series Specifications

General IconGeneral
BrandGojo
Model8 Series
CategoryTransmitter
LanguageEnglish

Summary

Transmitter Module Installation Procedure

Release Bottom Cabinet Portion

Press both cabinet latches to release the bottom portion of the cabinet.

Expose Pumphouse

Slide the bottom of the cabinet down to expose the pumphouse.

Remove Connector Cover

Remove the connector cover from the pumphouse.

Insert Transmitter Module

Insert the module into the left side of the pumphouse until it snaps into place.

Load Product Refill

Load the dispenser with the appropriate product refill if needed.

Verify Installation and LED Status

Slide cabinet up and wait for green LED. Check for issues if red or no LED.