This document is an operating manual for the Goldair 2000W Ceramic Tower Heater, model GCT325R. It provides general care and safety guidelines, instructions for operating the heater, and warranty information.
Function Description
The Goldair 2000W Ceramic Tower Heater is designed for household use to provide heating. It offers different heat modes (High, Low, and ECO) and includes a thermostat for temperature control, an oscillation function, and a timer. The heater is equipped with safety devices such as a tilt switch and a resettable thermal link to prevent overheating and ensure safe operation.
Important Technical Specifications
- Model: GCT325R (Item Code: CH0588)
- Supply: 220-240VAC 50Hz
- Wattage: 2000W
- Temperature Range (Thermostat): 15 to 30 degrees Celsius
- ECO Mode Temperature: Pre-set to 20 degrees Celsius (not adjustable)
- Timer: 1 to 12 hours (in 1-hour increments)
- Remote Control Battery: 1 x CR2025 coin type battery
- Remote Control Range: 3 metres
- Safety Devices: Tilt Switch, Resettable Thermal Link
Usage Features
Control Panel and Remote Control:
The heater can be operated using both the control panel on the unit and a remote control. The remote control performs the same functions as the control panel buttons. For best results, the remote should be aimed directly at the remote sensor on the front panel of the heater.
Power On/Off:
- To turn the heater on, press the ON/OFF button on the control panel or remote.
- To turn the unit off, press the ON/OFF button again.
Heat Settings:
Pressing the HEAT SETTING button allows selection of three heat modes:
- High (2000W): Provides maximum heating power.
- Low (1000W): Provides reduced heating power.
- ECO: Pre-set to maintain a temperature of 20 degrees Celsius. The temperature in ECO mode cannot be adjusted.
Thermostat Control:
- The up and down arrow buttons (ADJUST UP/DOWN) are used to set the desired comfort temperature between 15 and 30 degrees Celsius.
- Once the temperature is set, the display will show the current room temperature.
- The heating function will automatically turn off when the room temperature reaches the preset temperature and turn on again if the room temperature drops below the preset.
Timer Function:
- The heater includes a 12-hour timer.
- Press the TIMER button repeatedly to set the appliance to switch on/off automatically from 1 to 12 hours, in 1-hour increments.
Oscillation Function:
- The OSCILLATION button turns the heater's oscillation function on and off, allowing the unit to rotate and distribute heat more widely.
Cool-Down Period:
- To protect internal components, when the unit is turned OFF, the fan will continue to blow room temperature air for 30-60 seconds before shutting down to standby. It is crucial not to turn off the main power switch or unplug the heater from the wall during this cool-down period.
First Use:
- When the appliance is turned on for the first time, a slight odour or smoke may be released. This is a normal occurrence due to the initial heating of the elements and should not reoccur.
Maintenance Features
Regular Cleaning:
- Before Cleaning: Always unplug the heater from the mains supply and ensure it has cooled down completely.
- Dust and Fluff Removal: The common cause of overheating is dust or fluff accumulation. Regularly vacuum clean the air vents and grills to remove these deposits.
- Exterior Cleaning: Use a damp cloth (not wet) rinsed in hot soapy water to wipe the exterior of the heater to remove dust and dirt.
- Prohibited Cleaning Agents: Never use solutions such as petrol, thinners, or polishing agents.
- Drying: Ensure the heater is completely dry before plugging it back into the mains supply.
Service and Repair:
- The heater has no user-serviceable parts.
- Do not attempt to dismantle the heater.
- For service or repair, contact an authorised electrical service technician.
- If the supply cord is damaged, it must be replaced by the manufacturer, its service agent, or similarly qualified persons to avoid a hazard.
Safety Precautions (General Care):
- Always operate the appliance on a flat, stable, heat-resistant surface.
- Keep all objects at least 1 metre from the front, sides, and rear of the appliance to prevent fire risk.
- Do not cover the heater.
- Do not use the heater with external switching devices like timers or remote-control systems that switch it on automatically, as this poses a fire risk if the heater is covered or incorrectly positioned.
- Never leave the heater unattended when in use.
- Ensure hands are dry before handling the plug or main unit.
- Do not operate with the cord coiled up.
- Regularly check the supply cord for damage.
- Do not operate the appliance if it has a damaged cord, plug, or if it has malfunctioned, been dropped, or damaged.
- Do not twist, kink, or wrap the cord around the appliance. Ensure all cord is unrolled before use.
- It is recommended to plug the appliance directly into a wall socket. If an extension cord is used, it must be correctly specified, undamaged, and used safely.
- Do not remove the plug from the power socket by pulling the cord; always grip the plug.
- Do not place the cord under carpet or cover it with rugs or furniture. Arrange the cord to prevent tripping hazards.
- Do not place the appliance on bedding or thick/long carpet where openings may get blocked.
- Switch off the appliance and use the provided handle when moving it.
- Do not place the appliance close to radiant heat sources.
- Do not insert foreign objects into ventilation or exhaust openings.
- Do not sit on the appliance.
- Do not operate in areas where petrol, paint, or other flammable liquids are used or stored.
- Do not use this appliance in the immediate surrounds of a bath, shower, swimming pool, or other liquids.
- The appliance must not be immersed in any liquids.
- Do not place the unit in wardrobes or other enclosed spaces.
- This unit is not intended for use where foodstuffs, works of art, or delicate articles are stored.
Button/Coin Cell Battery Safety (for Remote Control):
- Button/Coin Cell Batteries are hazardous and must be kept out of reach of children at all times, whether new or used.
- These batteries can cause severe or fatal injuries in 2 hours or less if swallowed or placed inside any part of the body.
- Dispose of used batteries immediately.
- If a button/coin cell battery is suspected to have been swallowed or placed inside any part of the body, seek medical attention immediately. Contact the Australian Poisons Information Centre on 13 11 26 or the New Zealand National Poisons Information Centre on 0800 764 766 for fast, expert advice.
Need help?
To Next Page
General
