34
X. CARE AND MAINTENANCE
BEEP CODE #2 – LOW BATTERY VOLTAGE
The battery needs charging or there is a bad connection to the battery. Check the
connections to the battery. If the connections are good, try charging the battery.
BEEP CODE #3 - HIGH BATTERY VOLTAGE
An excessive voltage has been applied to the S-drive. This is usually caused by a poor
battery connection. Check the battery connections. NOTE: The error may only be present
when going down hill and power goes back to the batteries.
BEEP CODE #5 – SOLENOID BRAKE TRIP
The parking brake has a bad connection. Check the parking brake and motor
connections. Make sure all the system connections are secure.
BEEP CODE #6 – THROTTLE TRIP (OUT OF NEUTRAL)
A throttle trip is indicated. Make sure the throttle is in the neutral position before
switching on the scooter.
BEEP CODE #7 – THROTTLE TRIP/SPEED CONTROL FAULT (VOLTAGE ERROR).
A throttle trip is indicated. Indicates a problem with the throttle control or speed control.
BEEP CODE #8 - MOTOR DISCONNECTED
The motor has a bad connection. Check all the connections and leads between the motor
and the S-drive. Check the position of the freewheel switch.
BEEP CODE #9 – POSSIBLE CONTROLLER TRIP
A control system trip is indicated. Make sure all connections are secure. Check to make
sure each tire is properly inflated. See “Proper Tire Inflation” on page 33.
FOR YOUR CONVENIENCE, THESE DIAGNOSTIC FLASH AND E-CODES
ALONG WITH THE SERIAL NUMBER OF YOUR SCOOTER CAN BE FOUND UNDER THE
FLOOR MAT. THIS WILL ALLOW YOU TO ACCESS THIS IMPORTANT SERVICE
INFORMATION AT ANY TIME. IF POSSIBLE, PLEASE REFER TO THIS INFORMATION
BEFORE CONTACTING YOUR AUTHORIZED GOLDEN TECHNOLOGIES, INC.
PROVIDER.
To Next Page
Loading...