Operation
The spaside remote communicates with the base station on the Pro Logic/Aqua Logic
control unit using RF (radio frequency) technology. When you push a button on the
spaside remote, it sends a command and flashes the LED indicator once. After a brief
delay, the spaside remote receives a confirmation from the Pro Logic/Aqua Logic
base station and the LED indicator on the spaside remote will flash 2 times. This
double LED flash is your confirmation that the command has been successfully trans-
mitted to the control unit. If the LED doesn’t flash at all or else just flashes once after
you’ve pushed a button, refer to the Troubleshooting section for assistance in re-
solving these problems.
Valves POOL/SPA These buttons will allow you to select either pool or spa opera-
tion. You can not select spa spillover operation from the spaside
remote.
Filter ON/OFF The ON/OFF buttons allow manual operation that will override
any automatic control settings (e.g. timeclock). The manual
setting will remain active until the next scheduled automatic
turn on/off event. There are some exceptions:
If the Heater1 is operating and the heater cooldown function is
enabled, then pressing the OFF button will turn off the heater
and the pump will run for another 5 minutes to allow the heater
to cooldown before automatically turning off.
If the freeze protection feature is enabled and the air tempera-
ture is below the selected freeze protection threshold (38°F
default), then the pump will remain on to ensure that the pipes
do not freeze.
25
OFF
OFF
OFF
OFF
OFF
SPA
ON
ON
ON
ON
ON
POOL
G1-080315A-1
To Next Page
Loading...
