8. SERVICING Cont’d
ACCESSING FRYERS FOR SERVICING
WARNING
Moving a fryer filled with hot shortening may cause splattering of the hot shortening.
Extreme care must be exercised.
1. Switch off main power – Electrical lead and remove plug if fitted.
2. Remove restraining devices typically applied to the bottom or back of fryer.
3. Relocate fryer so that access can be obtained to perform necessary
maintenance.
4. After servicing has been completed and attach restraining devices.
SHUTTING FRYER(S) OFF WHEN CLOSING STORE
1. Turn off Main Switch
RECOMMENDED SPARE PARTS
• To ensure minimum downtime of the fryer in case the replacement of a part
is required. It is recommended that one each of the following parts be kept
in local stock.
• ETC00893-Digital Control
• MTH00238 Over temperature - Thermostat
• EPR00102 Probe
• ESW00007 Main Switch
Illustrations and complete listing of replaceable parts at the end of this manual.
FACTORY SERVICE & PARTS ORDERING
SERVICE PROBLEMS
Contact the factory direct by mail or telephone ( no collect calls accepted). Always
give the model and serial numbers of your fryer.
PARTS ORDERING
Customers may order parts directly from their local Authorised Parts Distributor.
For this address and phone number, call the factory. Factory address and phone
numbers are on the back of this manual.
IMPORTANT
GOLDSTEIN & CO WHOSE POLICY IS ONE OF CONSTANT IMPROVEMENT,
RESERVES THE RIGHT TO AMEND SPECIFICATIONS OF ANY PART OR
ASSEMBLY AND THE MATERIALS AND FINISHES COMPRISING THE COOL
ZONE FRYER AND ITS ACCESSORY EQUIPMENT WITHOUT PRIOR NOTICE.
IM013B2/p15
To Next Page
Loading...