All contents copyright 2014, GoldWing RC Version 2.0, Feb 2014
3. Loosen out the inner nut, then apply thread lock to the axle. Tighten the nut back in place, allow the thread
locker to dry.
4. Install the main wheel axles to the composite landing gear and tighten the nylon-insert lock nut. Install one
wheel collet onto the axle. Use a second wheel collar as a guide to leave a gap on the inboard of the axle. Use
a small drop of thread-lock and tighten in place. Slide the wheel onto the axle and install a second wheel
collar also using thread-lock on the set screw. For greater strength, filing a flat where the grub screw mounts
will stop the collet being able to be turned.
To Next Page
Loading...
