1
The Golfstream Vision Brake trolley is one of the lightest and easy to fold/unfold golf trolleys on the
market today. Add to this the super clear, large numeral colour LCD display, high grip tyres, easy off wheels
and no twist system to keep your bag rm, you will nd you have made a fantastic buying decision.
IN THE BOX
In the box you will nd your Golfstream Vision, battery and charger. Take the
battery and charger out and put them on charge by plugging the charger into the
battery and battery into the mains, making sure the red charging light is
illuminated. Once the light goes green your trolley is ready for use.
Now take a minute or two to register your guarantee
at www.golfstream.co.uk/guarantee and keep your original receipt in a safe
place so that in the unlikely need of a claim you have everything to hand.
QUICK START
1. Before your rst opening of the Vision please unwrap the bungee cords that
were wrapped around in manufacture. Now lift the handle into the fully erect
position, the central catch will lock with a reassuring click.
2.
Now, if using the supplied CaddyCell battery, plug it in and the screen will
illuminate. Initially “VISION BRAKE” will show, followed by Good Morning/
Afternoon or Evening”. You are now presented with a display showing
“0.0” ashing. Rotating the knob clockwise will change the speed setting
upwards. While the speed is low, the brake is applied in greater force down to
zero, less force the higher the speed goes. This is represented by Red for more
braking, green for less. Turn the speed to 0 and press the knob once, now
adjust the speed. You can stop the machine at any speed and it will resume at
that speed unless over speed 6.
3.
Please do not push the machine, always use power. As this is a brake machine,
there are no clutches on the wheel, therefore pushing will rotate the entire drive
train and this is undesirable.
O nce you have these basics, add the golf bag and away you go.
For a more in depth explanation of your new Vision Brake trolley, please read on.
When carrying the machine lift from the area highlighted
in the image, the magnetic catch will prevent it from aying
open. For a more permanent hold, the battery strap can be
used to go over the central tube. Lay the trolley at and lift
from the handle, the magnet will be released and you can
extend the handle upwards until it clicks into place.
Add the battery and your Vision is ready for action.
When you plug in your Vision the Vision Brake will be replaced with “0.0” ashing.
This is the speed indicator, whilst it is ashing no power is offered to the motor.
Rotating the control knob will change the display in 0.5 increments allowing you to
choose the exact speed to match your walking pace.
Open
from
here
To Next Page
Loading...