To Next PageTo Next Page
Need help?Do you have a question about the golmar SZENA and is the answer not in the manual?
General| Brand | golmar |
|---|---|
| Model | SZENA |
| Category | Intercom System |
| Language | English |
Details on monitor push button functions for calls, intercom, and disconnect.
Explanation of the bi-colour LED states indicating monitor status.
Instructions on managing the end of line jumper for video signal.
Guide to the identification label for repair and configuration.
Safe cleaning procedures for the monitor, avoiding abrasive chemicals.
Guidelines for assembling the monitor on a surface connection block.
Instructions on mounting the connection block to the wall at the correct height.
Steps for attaching the monitor to the connection block for surface mounting.
Guidelines for assembling the monitor within an embedding box.
Recommendations for positioning the embedding box at the correct height.
Instructions for breaking the flange to allow cable entry into the embedding box.
Steps for wiring and installing the embedding box flush with the wall.
Steps for attaching the monitor to the connection block for embedding mounting.
Guide to adjusting Brightness, Contrast, Colour, Call reception, and Audio volume via the user menu.
Configuration of Column, Monitor address, Master/Slave/Intercom modes.
Step-by-step guide to programming monitors via the door panel.
Checks for power, programming, and LED status when the system is inactive.
Guidance on adjusting audio levels and resolving volume problems.
Tips for reducing or eliminating audio feedback during calls.
Troubleshooting steps for display issues like brightness and contrast.
Diagnosis for when the monitor does not receive incoming calls.
Steps to verify door panel and monitor programming modes are correct.
