What to do if my GÖLZ Cutter machine does not work?
If your GÖLZ Cutter machine isn't working, first ensure the power supply cable is properly connected by firmly pressing the plug into the power socket and checking the cable for damage. Also, have the socket checked to ensure it has voltage. If these steps don't resolve the issue, the control switch may be damaged, and you should consult your local dealer for a replacement.
Why is my GÖLZ FT 200 machine cutting out of square?
Your GÖLZ Cutter machine might be cutting out of square because the tile supports are not at right angles with the cutting disc. To fix this, use a square to adjust the tile supports to 90° in relation to the cutting line of the disc. Alternatively, the disc may not be suitable for the material you are cutting, so replace it with a more appropriate disc.
Why does my GÖLZ FT 200 motor give off an unpleasant odor?
An unpleasant odor from your GÖLZ Cutter motor could be due to water seeping inside, a damaged capacitor, or damaged motor bearings. In any of these cases, unplug the power supply cable and consult your local dealer.
What to do if lubrication does not arrive at the disk with the pump running in my GÖLZ FT 200?
If lubrication isn't reaching the disc while the pump is running on your GÖLZ Cutter, the sprayer unit might be clogged. Dismantle the sprayer assembled inside the disc cover and remove any residuals.
To Next Page
General