Why my GÖLZ Cutter doesn't work?
If your GÖLZ Cutter isn't working, the possible causes include: no electrical power supply (check the power cable and connection), a defective power cable (change the power cable), a defective switch (change the switch), or a defective engine (change the engine).
What to do if there is no water on the blade of my GÖLZ Cutter?
If there is no water on the blade of your GÖLZ Cutter, consider the following possibilities: * Not enough water in the water tank: Refill with clean water. * Closed water tap: Open the water tap. * Clogged water system: Clean the water system and refill the water tank with clean water. * Defective water pump: Clean the water pump, and if cleaning doesn't help, replace it. * Water pump is off: Check the electrical power supply.
Why does the engine of my GÖLZ TS 200 Cutter stop during cutting?
The engine of your GÖLZ Cutter might stop during cutting due to: * Using the wrong blade for the application. * A defective or worn blade. In any of these cases, you should change the blade. Also, the issue might be that the cutting advance is too fast or there is undue pressure on the blade, so try to cut more slowly.
To Next Page
General