GÖLZ TS 200 - Engine; Setting up the Machine; Mounting; Changing the Blade

TS200 / TS250
Translation of the original operating instruction and spare parts list
- 18-
5007090-00
BA-E
®
4.3 Engine
4.4 Setting up the machine
Loosen the star knob screws on the legs to close this out. Set up the machine on a solid level and
stable surface.
4.5 Mounting / changing the blade
To mount a new blade, always do the following instructions:
• Switch off the machine and unplug the supply cable.
Attention: The cutting head must be set and detected with the control handle in a
raised position!
Attention: The cutting table must be saved with the transport lock.
Note: Read and observe the instructions to the engine!