TS200 / TS250
Translation of the original operating instruction and spare parts list
- 25-
5007090-00
BA-E
®
• Start the machine.
• Put your hand on the cutting handle.
• Push the cutting table slowly and without undue pressure
towards the rotating blade. The blade cuts the applied
material.
• During the cutting process set the cutting depth manual about
the cutter head handle.
Push about the table handle the
cutting table to the front and back again.
5.3.3 Cutting method: 45° bevel cuts
The machine enables to make fixed or multiple steps 45° bevel cuts.
To do 45° bevel cuts, please follow this procedure:
• Switch off the machine and make sure the blade is not
rotating.
• Loosen the two grip knobs on each side of the machine.
To Next Page
Loading...
Need help?
General
