GÖLZ TS 200 - 6 Maintenance and Care; Machine; Blade

TS200 / TS250
Translation of the original operating instruction and spare parts list
- 29-
5007090-00
BA-E
®
6. Maintenance and care
Spare parts must comply with the technical requirements specified by the manufacturer. Spare parts
from GÖLZ
®
can be relied to do so! Observe the following indications:
In accordance to the given cycles, the subsequently described maintenance work has to be enforced.
Also the wearing parts subject to no certain maintenance-intervals have to be checked regularly for
wear and to adjust if necessary or to exchange.
Vor jeder
Inbetrieb-
nahme
Nach
Arbeits-
ende
Wöchent-
lich
Bei
Störung
Bei
Beschädigung
Gesamte Maschine
Kontrolle
x x x
Säubern
x
Schneidflansch
Säubern
x
Austauschen
x
Motorwelle Säubern
x
Motor (Gehäuse und
Lüfter)
Säubern
x
Wasserbehälter Säubern
x
Wasserpumpe
Kontrolle
x x
Säubern
x
Wasserschläuche Leeren
x
Wasserdüsen Säubern
x
Führungsschienen
und -rollen
Säubern
x
Schraubenverbin-
dungen
Kontrolle
x
6.1 Machine
Clean the machine after each duty and check all functions. Replace all necessary parts that are out of
order or worn out immediately.
6.2 Blade
When ending a cutting job - check blade as follows:
Check segments for cracks or break-outs, Cracks between segment and core barrel,
Deformation and out of round wear.
In case of doubt, send the blade for repair.
Attention: All maintenance, repair and care work is only to be done if the motor
being stopped and the power supply is disconnected!