To Next PageTo Next Page
Need help?Do you have a question about the GOM ATOS III Triple Scan and is the answer not in the manual?
Provides critical safety information regarding laser use, electrical hazards, and handling precautions.
Details sensor configurations, measuring areas, distances, camera angles, and calibration objects for different models.
Illustrates camera positions (SO, 400, 800) and the function of eccentric stops for adjusting camera angles.
Step-by-step guide for changing sensor camera positions, including lens and filter adjustments.
Details the software-assisted process for setting up the sensor, registering measuring volumes, and adjusting parameters.
Details the calibration process using the CP40 calibration panel for various measuring volumes.
Describes the calibration procedure using the calibration cross CC 30 for large measuring volumes.
Explains how to load calibration data from the CD into the ATOS software for the first-time use of a measuring volume.
Explains how to enter calibration data for the CC 30 cross into the ATOS software.
Guides on preparing the sensor and software for the calibration process using the CC 30 cross.
Details the step-by-step calibration procedure using the CC 30 cross and the ATOS software.
General| Technology | Optical 3D scanning |
|---|---|
| Resolution | Up to 5 µm |
| Light Source | Blue Light Technology |
| Camera Resolution | 5 megapixels |
| Software | GOM Inspect |
