48
EN Use FR Utilisation
PL Użytkowanie RO Utilizare
IMPORTANT: The extraction rate of the hood will vary based upon the total power output selected on the
hob, as shown in the table below.
Each hob cooking zone has a maximum rated output of 10 comprising 1-9 and Boost (10).
Speed Level of the Hood Combined Power Output of the Hob
Speed 2 This speed will be selected when the combined power output of all zones is 8 or less. For
example Zone A is on 3 and Zone B is on 4.
Speed 4 This speed will be selected when the combined power output of all zones is between 9 and 24.
For example Zone A is on 3, Zone B is on 4 and Zone D is on 6.
Speed 5 This speed will be selected when the combined power output of all zones is between 25 and 32.
For example Zone A is on 9, Zone B is on 8, Zone C is on 7 and Zone D is on 6.
Speed P - Boost This speed will be selected when the combined power output of all zones is greater than 32.
For example Zone A is on 8, Zone B is on 9, Zone C is on 9 and Zone D is on 10.
Note:
1. Speed 1 and Speed 3 on the hood are not available when using the automatic function.
2. In automatic mode, if all cooking zones are turned off, the hood will automatically enter the Timer Mode and the
fan will start the countdown process as described in the "Setting the Timer" section below. This function can be
cancelled at any time by pressing either the Stop icon or the Auto Extraction Control icon
A
.
NOTE: Full power or Boost only operates for five minutes maximum to conserve energy and the fan speed
will automatically drop to speed level 5 after this time.
Setting the Timer
1. When the fan motor is on and the Timer Icon is pressed the Extractor Fan Key and the 360° Master Control Key
will flash showing the current fan speed.
2. The chosen speed level will remain in use for five minutes before dropping down to the next lowest speed. This
speed will remain in operation for two minutes before dropping down again. This will be repeated every two
minutes unless the speed is already at level 1 and then the fan will turn off.
3. Changing the fan speed during a current timer program will restart the countdown process again with a five
minute cycle.
4. If the Timer Icon is pressed again during a current timer program, the cycle will be cancelled. The Timer Icon
will revert to white and the current fan speed will remain on indefinitely.
5. The maximum timer program cycle is 15 minutes: 5 minutes on P and then 2 minutes each on speed 5 down
to speed 1.
Extraction
To Next Page
Loading...
Need help?
General
