09
EN Installation FR Installation
PL Montaż RO Instalare
EN
Electrical Installation
All installation must be carried out by a competent person or qualified electrician. Before connecting the mains supply
ensure that the mains voltage corresponds to the voltage on the rating plate.
Direct Connection
The appliance must be connected directly to the mains using an omnipolar circuit breaker with a minimum opening of
3 mm between the contacts.
The installer must ensure that the correct electrical connection has been made and that it complies with the wiring
diagram.
The cable must not be bent or compressed.
Regularly check the power cord for damage. If the supply cord becomes damaged, it must be replaced by the
manufacturer, its service agent or similarly qualified persons in order to avoid a hazard.
WARNING: This is a Class I appliance and MUST be earthed.
The appliance is supplied with a 3-core mains cable and must be connected to the electricity supply via a double pole
switch having a 3 mm minimum contact gap on each connector.
The Residual Current Device (RCD) must be rated at 16 Amps.
The wires in the mains lead are coloured in accordance with the following code:
Brown = L - Live
Blue = N - Neutral
Green and Yellow = - Earth
EUR UK
N
L
N
L
N
L
DOUBLE POLE SWITCHED
FUSED SPUR OUTLET
USE A 16AMP FUSE
(Blue)
(Brown)
(Green/Yellow)
To avoid the risks that are always present when you use an electrical appliance it is important that this appliance is
installed correctly and that you read the safety instructions carefully to avoid misuse and hazards. Please keep this
instruction booklet for future reference and pass it on to any future owners. After unpacking the appliance please
check that it is not damaged. If in doubt, do not use the appliance but contact Customer Services - see end of Care &
Maintenance section for details.
L
N
To Next Page
Loading...
Need help?
General
