Goodman GMVC95 - Auto-Comfort Mode; Standard Altitude Installations; Thermostats

14 www.goodmanmfg.com SS-GMVC95
product speciFications
DuringAuto-Comfortmode,thefurnacerampsupto50%ofthedemandforhalfaminute.Itthenrampsto
82%ofthefullcoolingdemandairowandoperatesthereforapproximately7½minutes.Themotorthen
stepsuptothefulldemandairow.Thismodespendsahalfminuteat50%airowOFFdelay.
auto-coMFort Mode
standard altitude installations
Gas Altitude Kit Orice
Manifold Pressure
Pressure Switch
Change
High Stage Low Stage
Natural 0-7000 Changeover None #43 3.5” W.C. 1.9” W.C. None
Propane 0-7000 LPM-03B & LPM-05 #55 10.0: W.C. 6.0” W.C. None
• For installation in Canada, gas furnaces are certied only to 4,500 ft.
• For GCVA installations above 7,000 ft., please refer to your Goodman distributor for required kit(s).
Model Description
CHT90-120 Cooling/Heating, Mechanical
CH70TG
Cooling/Heating, Digital,
Non-programmable
CHSATG Cooling/Heating, Mechanical
CTK01AA
ComfortNet communicating control
(2-stage cool/3-stage heat; programma-
ble/non-programmable;dual-fuel support)
H20TWR Heating Only, Mechanical
tHerMostats
Atwo-stagethermostatshouldbeusedwiththeGMVC95/GCVC9
furnaces. Two-stage thermostats control which ring rate is
used depending on the temperature difference between the
setpointandtheroomtemperature.Aproperlyusedtwo-stage
thermostatandfurnacewillmaintainamuchtightercontrolof
temperaturethanaconventionalsingle-stagethermostatand
furnace.Two-stagefurnaceshave“W1”and“W2”terminals.If
the thermostat has “Y1”and “Y2”cooling connections and a
single-stagecoolingsystemisused,connect“Y”onthefurnace
control to “Y1” on the thermostat. The accompanying table
describestwo-stagethermostatsthathavebeenconguredfor
usewiththesefurnaces.