To Next PageTo Next PageWhat to do if my Goodman Furnace fails to operate and the LED display shows no signal?
If your Goodman furnace isn't working and the integrated control module LED display shows no signal, first, check if the furnace and the integrated control module are receiving 115V power. Also, inspect the 115V circuit for any shorts and repair them. If the module is still not working, it might need to be replaced.
General| Model Series | GMVC96 BA Series |
|---|---|
| Efficiency Rating | Up to 96% AFUE |
| Fuel Type | Natural Gas or Propane |
| Heat Exchanger Material | Stainless Steel |
| Heating Capacity | 40, 000 to 120, 000 BTU/h |
| Input BTU | 40, 000 to 120, 000 BTU/h |
| Stages | Two-stage |
| Warranty | 10-Year Parts Limited Warranty |
Essential notices for users, recognition of safety symbols, words, and labels for safe operation.
Explanation of the 14-digit model number system and component identification.
Crucial safety warnings, precautions, and ESD steps for furnace installation and operation.
Guidelines for combustion air requirements and recommended furnace installation positions.
Annual inspection points for furnace components and guidelines for air filter maintenance and replacement.
Servicing condensate drainage system and performing heating performance tests.
Procedures for checking transformer phasing, voltage, thermostat, wiring, and general electrical components.
Testing primary, auxiliary limit controls, and flame rollout switches for safety and proper function.
Checking gas pressure, burners, orifices, and hot surface ignitors for optimal operation.
Diagnosing ignition control boards and checking the flame sensor for proper operation.
Reference tables defining diagnostic status codes and their corresponding causes and corrective actions.
Details on ClimateTalk modes and furnace control settings for AC/HP and overall operation.
