1
General Safety
Safety Disclaimer
NOTICE
• The information in this quick installation guide is subject to change due to product
updates or other reasons. All descriptions here are for guidance only.
• Before installations, read through the quick installation guide.
• All operations should be performed by trained and knowledgeable technicians who are
familiar with local standards and safety regulations.
• Check the deliverables for correct model, complete contents, and intact appearance.
Contact the manufacturer if any damage is found or any component is missing.
• Strictly follow the installation, operation, and conguration instructions in this guide
and user manual. The manufacturer shall not be liable for equipment damage or
personal injury if you do not follow the instructions. For more warranty details, please
visit https://en.goodwe.com/warranty.
NOTICE
The equipments are designed and tested strictly complies with related safety rules. Read and
follow all the safety instructions and cautions before any operations. Improper operation
might cause personal injury or property damage as the inverters are electrical equipment.
WARNING
• Make sure that the device is powered o before any operations.
• Ensure the cables are connected tightly, securely, and correctly. Inappropriate wiring
may cause poor contact or damage the device.
• Additional circuit breakers are recommended on the voltage input side to avoid
personal injury or device damage.
• If the voltage of the power grid uctuates, resulting in the voltage to exceed 265V,
in this case, long-term overvoltage operation may cause damage to the meter. It is
recommended to add a fuse with a rated current of 0.5A on the voltage input side of
the meter to protect it.
• CT direction: House-->Grid.
• Ensure to connect the voltage input side of the Smart Meter between Loads and
Household meter, CT and L cable connected correctly as well. Otherwise,the
monitoring data may be wrong.
• Pay attention to the silkscreens on the device when connecting the voltage input
cables. A wrong connection may cause damage to the device.
• Pay attention to the silkscreens on the device when connecting the CT and RS485 to
the Smart Meter. A wrong connection may cause incorrect reading values.
SAVE THESE INSTRUCTIONS
Please strictly follow these safety instructions in the user manual during the operation.
01 IMPORTANT SAFETY INSTRUCTIONS
To Next Page
Loading...
Need help?
General
