EasyManua.ls Logo

Goodyear INFLATOR 5000 - Intended Use and Safety Guidelines; General Safety Rules; Safety Symbols, Words, and Labels; Operating the Inflator with Vehicle Power

Default Icon
5 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
INTENDED USE
This product is intended for consumer use only.
GENERAL SAFETY RULES
WARNING
Read and understand all instructions. Failure to follow instructions can result in
electric shock, fire and/or serious personal injury. SAVE THESE INSTRUCTIONS
FOR FUTURE REFERENCE.
SAFETY SYMBOLS, WORDS AND LABELS
The safety instructions provided in this manual are not intended to cover all possible
conditions that may occur during product operation. Always use common sense and
pay attention to all WARNING and CAUTION statements in this manual.
WARNING
WARNING indicates a potentially hazardous
situation. Failure to avoid may result in serious
injury or death.
CAUTION
CAUTION indicates a potentially hazardous
situation. Failure to avoid may result in minor
personal injury.
3
TO OPERATE THE CORDLESS AIR INFLATOR WITH 12
VOLT POWER CORD PLUGGING DIRECTLY INTO THE
VEHICLE’S 12 VOLT POWER OUTLET/CIGARETTE
LIGHTER: This can be used if your Inflator’s rechargeable
battery is low or drained of power and you do not have time
to re-charge the Inflator before using:
1. To operate the Inflator, remove the air hose that is coiled up on the bottom of the
Inflator (see underneath the inflator). The air hose is 24” in length.
2. A metal “quick connect” valve is located on the end of the air hose. Simply put
the valve on the stem, etc., of the item you wish to inflate (sports needle, bicycle
tire valve, etc.). Lock into place by pushing the small arm on the valve down.
3. Take the provided 12’ power cord and plug the “plug-in” with the two holes onto
the two prongs located on the back of the handle below the round AC plug in.
Now plug the other end (the cigarette lighter adaptor plug in) into your vehicle’s
cigarette lighter. Turn the main power switch located on the back-side in the
middle of the handle to the “Power On” position. (See section 3 at the bottom of
page 3)
4. PRESET THE DESIRED PRESSURE BY TURNING THE GAUGE DIAL WITH
THE INDICATOR LINE POINTING TO THE DESIRED POUNDS OF
PRESSURE ON THE SCALE PANEL OF THE GAUGE. PLEASE MAKE SURE
YOU HAVE “DIALED IN: THE DESIRED AMOUNT OF PRESSURE YOU WISH
TO INFLATE TO.”
5. To turn the Inflator on push the power “On/Off” switch (located on the top of the
unit just below the green and yellow indicator lights) backward to the “On by Car
Battery” position
. The Inflator will now be operating directly off your Vehicle
cigarette lighter, “bypassing” your Inflator’s rechargeable battery.
ADAPTOR NOZZLES: Your Inflator has 3 inflation
nozzles which are located in the compartment by the
handle. An extra 15-amp fuse is also provided in the
same com
p
artment.
8