Elevator speed setting (rotation rate)
ELE light is solid-on → click SET → SPEED light flashes
Press and hold the SET button for 3 seconds to enter the adjustment mode, short
press the SET button until the indicator light ELE is solid-on and the SPEED light
flashes. The factory default elevator speed is 5 and you will see the BLUE light
flashing 5 times followed by a pause.
You can use the Elevator stick of the transmitter to raise and lower the setting, forward
stick giving a higher setting (faster rotation rate) and back stick to give a lower setting.
The number of consecutive flashes represents the setting level. The highest setting is
9 and the lowest setting is 1 flash (slowest rotation rate).
After completing setting changes, press and hold the SET button for 3 seconds to exit
and save, then the indicator light turns off and you are ready to fly. Or to move to the
next setting, click the SET button.
To Next Page
Loading...