Rudder gyro gain setting
RUD light is solid-on → click SET → GYRO light flashes
Press and hold the SET button for 3 seconds to enter the adjustment mode, short
press the SET button until the indicator light RUD is solid-on and the GYRO light
flashes. The factory default rudder gain is 5 and you will see the BLUE light flashing 5
times followed by a pause.
You can use the Elevator stick of the transmitter to raise and lower the setting, forward
stick giving a higher setting (higher gain) and back stick to give a lower setting. The
number of consecutive flashes represents the setting level. The highest setting is 9
and the lowest setting is 1 flash (lowest gain).
After completing setting changes, press and hold the SET button for 3 seconds to exit
and save, then the indicator light turns off and you are ready to fly. Or to move to the
next setting, click the SET button.
To Next Page
Loading...