GoPro Hero3 - Getting Started Manual

The GoPro has a wi function that lets you remotely control and preview one or
more GoPro’s.
• Download the GoPro app (The app is free).
• Press the wi button on the GoPro to create a wi hotspot.
• Connect to the GoPro wi. The password is “mobilelabs”.
Note that using the wi will drain the battery faster.
• Take the micro SD card out of the GoPro and insert it into the SD card adapter
(in the case).
• Then insert the SD card adapter into the PC/Mac.
• Delete your les after transferring them to your PC/Mac.
You can also transfer the data with the USB cable, but that will take longer.
GoPro
Getting Started
Wi (Preview)
Transfer Data to PC / Mac
Troubleshooting
• Disassemble the entire GoPro (even take out the battery and SD card).
• Hold down the Power and Shutter buttons for 10 secconds.
• Reinsert the battery.
• Restart the GoPro (If it doesn’t work try again).
• Reassemble the rest of the GoPro.
GoPro
Getting Started
The GoPro has 3 buttons
• Power / Mode to turn the camera on/off and
to switch modes (video, picture, settings).
• Shutter / Select to start and stop recording,
take pictures or select in setting mode.
• Wi to turn wi on/off.
• Use the Power / Mode button to switch between video, burst, photo, time-
lapse and settings.
• Video for video recording
• Burst for taking 30 photos per second
• Photo for taking pitures
• Time-lapse for taking pictures in set intervals
• Use the Shutter / Select button in setting mode to change the resolution, eld
of view, frame rate etc.
For more detailed information go to: http://abekislevitz.com/gopro-getting-started/
Buttons
Modes & Settings