USING THE LCD BACPAC
The camera’s default setting keeps the LCD screen
powered on. Below are options to change how the
LCD powers o.
CAMERA SET MENU OPTIONS LCO AND LCF
Check Page 2, section “Firmware Update”, to ensure your
camera has the necessary rmware update for your LCD
screen. If so, proceed to Steps 1 & 2 below:
1. LCO (default): LCD ON. This setting keeps the LCD
screen powered on, continuously, while the camera
is on. LCD will only power o if the camera is turned
o or if you quickly press the side LCD button.
2. LCF: LCD OFF. This setting auto powers the LCD
screen o 60 seconds aer the last camera button
press. The camera will remain on and only the LCD
will power o. If recording videos or photos, the
recording will continue uninterrupted while the
screen is powered o. A quick press of any button
will power the LCD screen back on.
TURNING LCD SCREEN ON/OFF
1. Pressing the LCD button quickly will power the
screen on and o when in preview mode.
6
To Next Page
Loading...
Need help?
General
