SECUTEST ST BASE(10) / PRO and SECULIFE ST BASE(25)
4 Gossen Metrawatt GmbH
• The test instrument is equipped with
fuses. The test instrument may only be
used as long as the fuses are in flawless
condition. Defective fuses must be
replaced.
• Do not perform any measurements in
electrical systems with the test Instru-
ment. It has been neither designed nor
approved for this purpose.
• Plugging in the measurement cables
must not necessitate any undue force.
• Never touch conductive ends (e.g. of
test probes).
• Fully unroll all measurement cables
before starting a test/measurement.
Never perform a test/measurement with
the measurement cable rolled up.
• Avoid short circuits due to incorrectly
connected measurement cables.
• Conduct a probe check after completing
each test.
• The test instrument must be operated
within the same electrical system as the
test object.
• Unexpected voltages may occur at
devices under test (for example, capaci-
tors can be dangerously charged). Take
appropriate precautions.
• The fuses may only be replaced when
the test instrument is voltage-free, i.e. it
must be disconnected from mains sup-
ply power and may not be connected to
a measuring circuit.
The fuse type must comply with the
specifications in the technical data or the
labeling on the test instrument.
• Test instruments with feature M01: The
test instrument is equipped with a Blue-
tooth
®
module. Determine whether or
not use of the implemented frequency
band of 2.402 to 2.480 GHz is permissi-
ble in your country.
• Always create a backup copy of your
measurement data.
Please refer to the operating instructions
for further information (see section 3,
“Documentation”).
• Observe and comply with the respec-
tively applicable national data protection
regulations. Use the corresponding func-
tions provided by the test instrument
such as password protection, as well as
other appropriate measures.
To Next Page
Loading...
