Digital Hot Air Frying Machine XL
EN
23
with the device, the condition
ofthe food should be checked
inbetween times to ensure that
it does not burn.
8. When the set time elapses, the device
automatically switches to standby
mode. The fan continues to run for
afew more seconds.
9. Open the door, remove the cooked
food from the cooking chamber (3)
and place it down on a heat-resistant
surface.
If the rotating basket or rotating spit
is being used, use the removal tool(9)
to remove it (see the “Accessories”
chapter).
10. Disconnect the device from the mains
power.
11. Clean the used accessory after it has
cooled down (see the “Cleaning and
Storage” chapter).
Briefly Pausing the Cooking Process
If the cooking process is to be paused
toturn the ingredients or add further
ingredients, for example, open the
door(4).
The countdown of the cooking time
ispaused. It resumes once the door
isclosed.
L
If the cooking process is paused
for more than approx. 13minutes,
the device automatically switches
to standby mode. The display(11)
shows OFF.
Ending the Cooking Process
Prematurely
To end the cooking process before the
set cooking time elapses, touch (19)
for approx. 2 seconds untilOFF appears
on the display.
CLEANING AND STORAGE
Please Note!
■ Allow the device to cool down com-
pletely before cleaning it.
■ Never spray hot water onto thehot
accessories to prevent material
damage.
■ Do not use any sharp or abrasive
cleaning agents or cleaning pads
toclean the device. These may dam-
age the surfaces.
• The door(4) can be detached from
the main unit for cleaning. To do this,
open a gap in the door and pull it out.
After cleaning, insert the completely
dry door into its holders and close.
1. Wipe down the outside of the main
unit and the cooking chamber(3),
the door(4) and the heating element
with a clean, damp cloth if necessary.
Do not clean in the dishwasher or
immerse in water!
2. Clean the used accessories with
detergent and warm water or in the
dishwasher.
To maintain the quality of the parts
for as long as possible, they should
preferably be rinsed by hand.
In the case of stubborn dirt, soak in
warm water and detergent before-
hand.
3. Allow all parts to dry completely
ordry them off.
4. Store the device in a clean, dry place
so that it is out of the reach of children
and animals.
11216_Inlay_DE-EN-FR-NL_A5_V2.indb 2311216_Inlay_DE-EN-FR-NL_A5_V2.indb 23 12.12.2022 09:12:4912.12.2022 09:12:49