21 EN
WARNING – Danger of Fire
■ Do not use the device in rooms containing easily ignitable substances or poisonous
and explosive fumes.
■ Do not operate the device in the vicinity of combustible material. Do not place any
combustible materials (e. g. cardboard, paper, wood or plastic) in or on the device.
■ Do not connect the device along with other consumers (with a high wattage) to a mul-
tiple socket in order to prevent overloading and a possible short circuit (fi re).
■ Do not use any extension cables.
■ Never place the device on a soft surface, do not insert anything into the ventilation
openings of the device and make sure that these do not become clogged. The device
could otherwise overheat and be damaged.
■ Make sure that foodstuff s containing oil and fats are not overheated.
■ Do not cover the device during operation in order to prevent it from catching fi re.
■ In the event of a fi re: Do not extinguish with water! Smother the fl ames with a fi re
blanket or a suitable fi re extinguisher.
NOTICE – Risk of Damage to Material and Property
■ Do not place any metal foil packaging or tools in the device.
■ The device must be switched off when inserting or removing the mains plug.
■ Never pull or carry the device by the connection. When you pull it out of the plug
socket, always pull on the mains plug and never the mains cable!
■ Never lay or place heavy objects on the device or the connection.
■ Pull the mains plug out of the plug socket if an error occurs during operation, when
there is a power cut or before a thunderstorm.
■ Protect the device from other heat sources, naked fl ames, sub-zero temperatures,
persistent moisture, wet conditions and impacts.
■ Use only original accessories from the manufacturer in order to guarantee that there
is no interference that may prevent the device from working and to avoid possible
damage.
Before Initial Use
• Remove any possible fi lms, stickers or transport protection from the device. Never
remove the rating plate and any possible warnings!
• Before you fi rst enjoy any fried food, we recommend that you carry out a trial run to
remove any possible production residues. To do this, allow the device to heat up on
the highest temperature setting for approx. 15 minutes without any food in it (see the
“Using the Device and Preparing Food” chapter). Make sure that the room is well
ventilated as you do this!
When the device is fi rst used, production-related additives (e. g. grease) may
cause a small amount of smoke and / or an odour to be produced. This is normal
and not a device defect.
• Clean the device and all accessories thoroughly (see the “Cleaning, Care and
Storage” chapter).
To Next Page