FCC and ISED Canada Statement
This device complies with Part 15of the FCC Rules and Industry
Canada licence-exempt RSSstandard(s). Operation is subject to
the following two conditions:
(1) This device may not cause harmful interference, and (2) This
device must accept any interference received, including
interference that may cause undesired operation.
Warning: Changes or modications not expressly approved by
the party responsible for compliance could void the user's
authority to operate the equipment.
Le présent appareil est conforme aux CNR d'Industrie Canada
applicables aux appareils radio exempts de licence. L'exploitation
est autorisée aux deux conditions suivantes :
(1) l'appareil nedoit pas produire de brouillage, et
(2) l'utilisateur de l'appareil doit accepter tout brouillage
radioélectrique subi, même si le brouillage est susceptible d'en
compromettre le fonctionnement.
NOTE: This equipment has been tested and found to comply with
the limits for a Class B digital device, pursuant to Part 15of the
FCC Rules.
These limits are designed to provide reasonableprotection
against harmful interference in a residential installation. This
equipment generates uses and can radiate radio frequency
energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communica-
tions. However, there is no guarantee that interference will not
Non aprire o tagliare la luce della fune.
Per ridurre il rischio di strangolamento, il cablaggio essibile
collegato a questo apparecchio deve essereefficacemente ssato
alla parete se il cablaggio è a portata di mano.
Non interconnettere parti di questa catena luminosa con parti di
un'altra catena luminosa del produttore.
L'interconnessione deve essere effettuata solo mediante l'uso dei
connettori forniti. Eventuali estremità aperte devono essere
sigillate prima dell'uso.
To Next Page
Loading...
