MAINTENANCE OPERATION
ASSEMBLY /
INSTALLATION
GETTING STARTED
4
EN
SAFETY /
SPECIFICATIONS
GENERAL SAFETY INSTRUCTIONS
IMPORTANT: It is your responsibility to:
• Know and follow applicable national, state and local safety codes
pertaining to installing and operating electrical equipment for use with
flammable liquids.
• Know and follow all safety precautions when handling petroleum fuels.
• Ensure that all equipment operators have access to adequate
instructions concerning safe operating and maintenance procedures.
Observe all safety precautions concerning safe handling of petroleum fuels.
To prevent physical injury or property damage, observe
precautions against fire or explosion when dispensing
fuel. Do not operate the meter in the presence of any source of ignition including
running or hot engines, lighted tobacco products, gas or electric heaters, or any
type of electronic device. A spark can ignite fuel vapors.
Avoid prolonged skin contact with petroleum fuels. Use
protective goggles, gloves and aprons in case of
splashing or spills. Change saturated clothing and wash skin promptly with
soap and water.
Any components such as hose, nozzle, or pump added to
your meter must be statically grounded and approved for
use with petroleum fuels.
This product shall not be used for pumping fuel or other
liquids into aircraft.
SPECIFICATIONS
M30-G6N, M30-L6N, M30-G8N, M30-L8N, M30-G8B, & M30-L8Bf
Dimensions
A. Meter Assy Width 5.91 in. (15.01 cm)
B. Meter Assy Height 7.88 in. (20.01 cm)
C. Meter Assy Depth 5.21 in. (13.23 cm)
Figure 1
C
B
A
To Next Page
Loading...
