GPO 746 - Dial Plan

Dial Plan
Thephonesendsthedialedstringonceitmatchesoneofthepre-congureddialplans.
Dialing Plan page:
Dialplanpage,eachpageissetto5records
Dialing Timeout: (Default, 6)
Thephonesendsthedialedstringafterdialingtimeoutifnofurtherinput.Rangingfrom
1~10.
Sharp Dial: (Default, Enable)
Press#attheendofadialedstringwillsendthecallifthisisenable.(the#willnotbein-
cludedinthedialedstring)Ifthisisdisable,adialedstringwillonlybesentifitmatchesadial
plan.
Passable Match Timeout:
Thephonesendsthedialedstringafterthesettledtimeoutiftheinputmatchespartialof
predenedAbbr.code.Rangingfrom1~10.
To create a new Dial plan
Press“New”button
Switch: Toenableordisablethedialplan.(Default,Enable)
Abbr.Code:Tollinthedialingsyntax.(PleaserefertoDialPlanSyntaxbelow)
5
GPO WEB CONFIGURATION
Syntax Description
X Denesadigitlength.
 Ex.,(+02)5xxx,add02asaprexifthediallingstringstartswith5andisfollowedby3digits.
? Matchesanynumberofdigits.
 Ex.,(+02)5?,add02asprexifdialedstringstartswith5andisfollowedbyanynumberofdigits.
(-) Removesaprexorpostx.
 Ex.,1234(-34),removestwodigitsofthepostxifthediallingstringis1234.
(+) Addsaprexorpostx.Ex.,(+02)1234,adds02asaprexifthediallingstringis1234.
Y Denethedialleddigitmatches0or1
 Ex.,1Yxx,iftheseconddigitis1or0andtotal4digits.Anexamplematchis1034or1145
N Denethedialleddigitmatchesbetweenof2and9.
 Ex.,9Nxxxxxx,iftherstdigitstartsbetween2and9thenfollowedby6digits.
 Anexamplematchis92123456,93123456,94123456….or99123456.
, Thephoneplayseconddialtoneif“,”isusedafteradigit.For,example,“9,“
 PS:Abbr.Codecan’tbeonlysyntax;itmustbewithatleast1digit.
 Forexample,Yxx,NYYxorNxxxisapplicable.