GPRINTER GP-80160 - User Manual

Wireless printer Installation Guide
1. Connect the Printer to the power and power on the Printer
2. USB driver installation: Install Driver Installer.exe, and restart PC.
3. Plug the USB Dongle into the Computer USB socket; “Prolific
USB-to-Serial COMM Port” will pop up at the right and bottom edge of the
PC monitor.
4. Install the Printer Driver.
During installing the printer driver, when reaching below diagram step, keep all
data as showing in the diagram.
5. Restart the Computer
6. Select “My Computer”, and click the right button of Mouse, select
“properties/hardware/device manager/ports (Com & LPT)”; click “Ports
(COM & LPT), find “Prolific USB-to-Serial COMM Port (COM?)”, “COM?” is
the COM Port of the USB Dongle.

Summary

Printer Driver Installation and Configuration

Detail Setting Configuration

Configure printer driver settings including module, name, and port parameters as per the diagram.

COM Port Configuration and Testing

Device Manager COM Port Setup

Locate and identify the COM port assigned to the USB Dongle via Device Manager.

Control Panel Printer Port Setup

Configure the printer's COM port settings in the Control Panel to match the USB Dongle's assigned port.

Print Test Page

Perform a printing test to verify the printer installation and configuration.

GPRINTER GP-80160 Specifications

General

Print Method	Thermal Line Printing
Print Width	72mm
Printing Speed	160mm/s
Resolution	203 DPI
Paper Width	80mm
Auto Cutter	Yes
Print Command	ESC/POS
Power	DC 24V/2.5A
Interface	USB, Ethernet, Serial
Line Spacing	3.75mm (Adjustable by commands)
Column number	48