EasyManua.ls Logo

GPX C232B User Manual

GPX C232B
2 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Page #1 background imageLoading...
Page #1 background image
Warning: Changes or modications to this unit not expressly approved by the party
responsible for compliance could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits
are designed to provide reasonable protection against harmful interference in
a residential installation. This equipment generates, uses, and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment
does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
USER’S GUIDE
V: 615-01
C232B Clock Radio with Dual Alarm
FCC Warnings
Introduction and Setup
Plug the included AC/DC power adapter into
the DC POWER INPUT on the dock and an AC
power outlet to power the dock.
Power
The battery backup is intended for short
power outages only. The clock radio’s primary
functions cannot run off of the battery backup
alone.
Requires 2, AAA-size, batteries (not included)
Battery Backup
PM Indicator
Lights when the time
is in the PM.
Dimmer
Press to dim the
display.
Tuning/Min/Hour
Press to tune the
radio.
Press to adjust the
minute or hour when
setting the clock or
alarm.
Clock/Mem
In Off mode, press
and hold to begin
setting the time.
In radio mode, press
to cycle through
preset stations.
LED Display
Source/AL Off
Press and hold to turn
off the radio.
Press to turn off the
alarm.
Snooze/Sleep
Press to snooze the
alarm after it sounds.
Press repeatedly to
set the sleep timer.
Alarm 1 Buzzer/
Radio Indicator
Lights when the
alarm 1 is on and set
to buzzer or radio.
Alarm 2 Buzzer/
Radio Indicator
Lights when the
alarm 2 is on and set
to buzzer or radio.
Volume/AL1/AL2
Press to adjust the
volume.
Press to begin setting
Alarm 1 or Alarm 2.
For Warranty Information and the most up-to-date version of this User’s Guide, go to www.gpx.com Customer Service: 1-888-999-4215
Email Support: prodinfo@dpiinc.com, Email Parts: partsinfo@dpiinc.com
Copyright © 2012 Digital Products International (DPI, Inc.) All other trademarks appearing herein are the property of their respective owners.
Specications are subject to change without notice.
Question and Answer IconNeed help?

Do you have a question about the GPX C232B and is the answer not in the manual?

GPX C232B Specifications

General IconGeneral
Radio typeClock
Tuner typeDigital
PLL synthesizer-
Supported radio bandsAM, FM
Preset stations quantity20
RMS rated power- W
Number of built-in speakers1
Display typeLED
Backlight colorRed
Display diagonal1.2 \
Antenna typeFM/AM
Product colorBlack
Connectivity technologyWired
Apple docking compatibilityNot supported
Compatible battery sizesAAA
Number of batteries supported2
Cables includedAC

Summary

FCC Warnings

Introduction and Setup

Power Connection

Plug the AC/DC power adapter into the DC POWER INPUT on the dock and an AC power outlet.

Battery Backup Functionality

Intended for short power outages only; primary functions cannot run off the battery backup alone.

Clock and Sleep Timer Operations

Setting the Clock Time

Press and hold Clock/Mem, adjust hour/minute using Hour/Min buttons, then press Clock/Mem to finish.

Setting the Sleep Timer

Press Snooze/Sleep repeatedly to set timer (90-10 min or OFF); unit powers off automatically.

Alarm Functions

Setting the Alarm

Press and hold Al1/Al2, adjust hour/minute, select Buzzer/Radio, set volume if needed.

Cancelling an Alarm

Press Al1/Al2 repeatedly until the indicator is no longer lit to cancel.

Snooze and Alarm Reset

Press Snooze/Sleep to delay alarm 9 mins. Press Source/AL Off to turn alarm off until next set time.

Radio Operations

Tuning the AM or FM Radio

Press Source/AL Off to turn on, switch bands with Source/AL Off, tune with Tun+/- buttons.

Saving and Tuning Preset Stations

Save stations by holding Clock/Mem; cycle through presets by pressing Clock/Mem.

Radio Reception Tips

Adjust FM antenna position for better FM reception; adjust clock radio position for AM.

Related product manuals