Graco 214895 - User Manual

Questions and Answers

G
gregoryandersonAug 11, 2025
What to do if the pressure creeps above setting on my Graco 214895?
- A
  Andrew VegaAug 12, 2025
  If the pressure creeps above the setting on your Graco Controller, there could be several reasons: * The air regulator or line (214980 only) might be damaged or clogged. In this case, clear any obstruction in the line and service the regulator if necessary. * The diaphragm (22) could be damaged, requiring replacement. * The seat (16) might be leaking, in which case you should replace the ball (20), seat, and gasket (15).
T
Tony CollinsAug 19, 2025
Why is there no pressure regulation in my Graco Controller?
- T
  Thomas MoralesAug 19, 2025
  If you're experiencing no pressure regulation with your Graco Controller, it could be due to a damaged or clogged air regulator or line (214980 only). Try clearing any obstructions in the line and servicing the regulator if necessary. Another possible cause is a damaged diaphragm (22), which would need to be replaced.
E
Erika LewisAug 27, 2025
What to do if the pressure drops below setting on my Graco 214895 Controller?
- P
  pandrewsAug 27, 2025
  If the pressure drops below the setting on your Graco Controller, consider the following possibilities: * A damaged or clogged air regulator or line (214980 only) could be the culprit. Clear any obstructions and service the regulator. * The supply line might be empty or clogged. Fill or flush the supply line. * A clogged air spray gun or fluid dispensing valve could also cause this issue. Replace it and consult the gun or valve manual for service instructions. * The regulator might be used beyond its rated flow capacity. Install additional regulators.
G
Garrett WilcoxSep 3, 2025
What to do if fluid leaks from under the cap of my Graco 214895 Controller?
- J
  Jose LeeSep 3, 2025
  If fluid is leaking from under the cap of your Graco Controller, it could be due to a loose cap (7). Tighten the screws (1) in the sequence shown in the Service section. Alternatively, the gasket (26) might be worn and need replacement.