To Next PageTo Next PageWhat to do if the Graco InvisiPac HM25 Controller doesn't read input from PLC?
If the Graco Controller isn't reading input from the PLC, the issue might stem from an improper input signal from the PLC or a broken wire. Check the wiring between the pattern controller and the PLC to ensure it is correctly connected.
Why is the Graco Controller output not being read by the PLC?
If the PLC isn't reading the output from the Graco Controller, it could be due to an improper interface with the PLC or a broken wire. Check the wiring between the pattern controller and the PLC.
General| Model | HM25 |
|---|---|
| Brand | Graco |
| Series | InvisiPac |
| Display | LCD |
| Connectivity | Ethernet, USB |
| Zones | Up to 6 |
| Frequency | 50/60 Hz |
| Type | Hot Melt Controller |
| Dimensions | Varies depending on configuration |
| Weight | Varies depending on configuration |
| Voltage | 200-240 VAC |
Safety instructions regarding electrical hazards during operation and maintenance.
Information on high-pressure fluid hazards and necessary precautions.
Safety information regarding hazardous fluids and toxic fumes.
Safety guidelines to prevent injury or death from improper equipment use.
Safety warnings related to moving components and avoiding injury.
Recommendations for protective gear to prevent serious injury.
Warning about hot surfaces and fluids, and precautions to avoid burns.
Precautions to prevent fire and explosion in areas with flammable fumes.
Warnings about chemical reactions with aluminum in pressurized equipment.
Steps for connecting the power supply and ADM to HM25/HM50 systems.
Procedure for mounting the control board into the InvisiPac system.
Instructions for mounting the pattern controller and ADM for external models.
Steps for integrating external models with HM25 or HM50 systems.
Procedure for connecting the electrical power cord to the system.
Steps to connect the ADM to the pattern controller for external models.
Instructions for setting up the system in a standalone configuration.
Instructions for connecting the pattern control board in external setups.
Procedure for updating the system software for compatibility.
Procedure for adjusting gun placement accuracy for high-speed applications.
Steps to calibrate line speed settings for accurate product length measurement.
Procedure for adjusting fluid pressure based on line speed for PC-8e.
Adjusting fluid output for modulated beads without a pressure regulator.
List of error codes, their causes, and recommended solutions.
