12 308899
Installation
Ceiling Mounting Directly to an I-Beam
The reel base has slots (A) to allow two screws to be
started before mounting the reel to the support. Using
the template (B) provided, drill holes in the I-Beam (C).
See Fig. 5.
Fig. 5
C
B
A
03719A
Ceiling Mounting to an I-Beam Without
Drilling Holes (See mounting bracket (D)
in Mounting Accessories on page 30.)
1. Secure two accessory mounting brackets (D) as
shown in Fig. 6. Use two mounting brackets for
each 1- to 3-capacity mounting channel (303).
2. Position the adjustable clamps (E) of the mounting
brackets (D) over the I-Beam (C), and tighten
them securely. See Fig. 6.
1655
Fig. 6
E
C
D
303
303
3. Slide the hose reel onto the base plate (304).
Install the hold-down plate (302) and capscrew
(301). Tighten the screw firmly. See Fig. 7.
Fig. 7
1640A
303
304
301
302
Wall Mounting
1. Select the reel bank mounting location. Mount the
reel to a wall, using the provided template (B) for
laying out the holes you drill.
You can mount an accessory base plate (304) to
the wall for easier removal of the hose reel for
servicing. See Fig. 8.
2. Slide the hose reel onto the base plate (304) and
install the hold-down plate (302) and capscrew
(301). Tighten the screw firmly. See Fig. 8.
Fig. 8
302
B
03720A
304
301
To Next Page
Loading...
