7308899
Hose Reels and Reel Assemblies
Bare Hose Reels
One of these bare reels is used in each reel assembly
in this manual. Bare reels do not include hoses,
valves, or enclosures. The three bare hose reels are
as follows:
D Air Reel Model 240957, for air and water.
1800 psi (12 MPa, 124 bar) maximum working
pressure. See page 23.
D Oil Reel Model 240961, for pourable lubricants.
1800 psi (12 MPa, 124 bar) maximum working
pressure. See page 25.
D Grease Reel Model 240965, for grease.
8000 psi (55 MPa, 552 bar) maximum working
pressure. See page 27.
NOTE: Bare Hose Reel 240957 is designed to be
corrosion-resistant, for longer product life, when used
with water, anti-freeze solutions (ethylene glycol or
propylene glycol), and windshield wash solutions
(typically methyl alcohol diluted with water).
Basic Hose Reel Assemblies
These assemblies include a bare reel, supply hose,
hose inlet kit (page 29), and hose stop kit. There are
three types of basic hose reel assemblies:
D Low-pressure, for air and water, uses bare hose
reel 240957. See page 23.
180 psi (1.2 MPa, 12 bar) maximum working
pressure.
D Medium-pressure, for oil and light lubricants, uses
bare hose reel 240961. See page 25.
1800 psi (12 MPa, 124 bar) maximum working
pressure.
D High-pressure, for grease, uses bare hose reel
240965. See page 27.
5000 psi (34 MPa, 345 bar) maximum working
pressure.
Open Hose Reel Dispensing Assemblies
These assemblies include a basic hose reel assembly
and a dispensing valve option. Some models include
an electronically metered dispensing valve. See the
table on page 8.
Enclosed Hose Reel Dispensing Assemblies
These assemblies
include an open hose reel
assembly, Side Enclosure Kit 218546 (page 28), and a
dispensing valve option. Some models include an
electronically metered dispensing valve. End
Enclosure Kit 218548 (page 28) must be purchased
separately—one kit per bank of reels. See the table
on page 9.
Metric conversions for hoses are as follows:
1/4” ID x 20’ (6 mm x 6.1 m)
1/4” ID x 35’ (6 mm x 11.5 m)
1/4” ID x 40’ (6 mm x 12.2 m)
3/8” ID x 40’ (10 mm x 12.2 m)
1/2” ID x 16’ (12 mm x 4.9 m)
1/2” ID x 25’ (12 mm x 7.6 m)
To Next Page
Loading...
Need help?
General
