Graco 311365G - Page 29

Pressure Control Board
311365G 29
Installation
1. Install o-ring (20) and transducer (86) in
filter base (67). Torque to 35-45 ft-lb (47-61
N•m). Install grommet onto transducer (86)
and transducer into control box.
2. Connect transducer connector (E) to motor
control board (95).
3. Install control box (61) and control panel
(68) with four screws (39).
4. Connect potentiometer connector (C) to
motor control board.
5. Install cover (96) with four screws (38).
ti7447a
40
67
20
86
ti13496a
E
95
ti12999a
ti7458a
39
61
68
ti13494a
C
ti12997a
38
96
ti13493a