Graco 8H98 - Vehicle Installation Guide; Rear Facing Installation

17
 The shoulder harness -534 lay across child’s shoulders according to height
(Fig. 9).
The position of shoulder harness -534 be set slightly above child’s shoul-
ders.
Installation to the Vehicle
(Rear Facing Mode, for child under 13 kg)
Note that this mode must /.,9 be used for child weighing under 13 kg (ap-
proximately 1 year old or under)
(Fig. 11).
$/./4 install on vehicle seat equipped with safety airbags (Fig. 12).
It is highly recommended to have your car seat installed at the back seats of
your vehicle.
Note that you -534 adjust the car seat to the most reclining angle, or an-
gle 5, in rearfacing Mode. (Turn to
page 16 for adjustment details)
Both top bar and inner cushion -534 be installed in rearfacing mode.
 Attach the inner cushions to the seat (including the Head Pad, Seat Pad, and
Protective Crotch Strap)
• Inner cushion is designed to provide extra protection and comfort for infant
under
• Child under
-534 use this car seat with inner cushions
(Fig. 13).
• The inner cushion is removable for washing.
Fig. 13.1 Protective crotch strap
Fig. 13.2 Head pad
Make sure to adjust the shoulder harness to the appropriate height when us-
ing the inner cushions. (Turn to
page 16 for adjustment details)
 Use of top bar (Fig. 14).
Note that the insertion is directional.
Do not use the top bar as a lifting handle.
 Buckle the vehicle seat belt
(Fig.15).
 Installation of vehicle seat belts (Fig.16).
GB GB
6 months old
.
6 months