79
Locking Latchplate and ELR Retractor
A latchplate that holds the lap belt snug after
it has been adjusted; contains a metal bar on
the underside of the hardware that “locks” the
belt in position.
When installing the car seat, route the
vehicle seat belt through the proper belt path
and buckle it in. Then, pull upwards on the
shoulder belt so that the lap belt gets tight
around the car seat.
Grab the sides of the seat at the belt path and
slide the seat side-to-side and front-to-back.
The seat should not move more than 1”
(2.5 cm).
79
To Next Page
Loading...
