EasyManua.ls Logo

Graco Contender Slim User Manual

Graco Contender Slim
90 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Page #1 background imageLoading...
Page #1 background image
GRACO CONTENDER SLIM
Type: Convertible
Last date made: Current
First made: 2021
Weight limits: 5 to 40 lbs. rear facing,
22 to 65 lbs. forward facing; forward facing not
recommended for children under two.
Harness: 5-point harness
P. 1 of 2
Harness: Shoulder straps are attached to a splitter plate behind seat. Pull
strap end in front of seat to tighten harness. Lift lever at lower front of seat
and pull on shoulder straps to loosen. Harness covers MUST be used for
forward-facing child weighing 25 lbs. or less.
Harness slots: There is one set of slots, which may be raised or lowered
to one of eight positions by grasping handle at top of headrest (diagram 1).
Be sure headrest is locked into place once adjusted. When head
support is in lowest position, pull flap forward (diagram 2).
Crotch strap: Adjustable. The crotch strap is sewn to a metal anchor
which must lie flat against underside of seat. To change slots, turn metal
anchor sideways, feed up through shell of restraint, and reinsert through
desired slot. Crotch strap should be close to, but not underneath child. If
lower anchor strap/safety belt is in rear-facing belt path, be sure it is in
front of buckle strap when buckle is in inner-most position and behind
when in the outer-most position (diagram 3).
Angle adjustment: Reclined position (diagram 4)
must be used for rear-facing; upright position
(diagram 5) must be used for forward-facing. Ball in
level indicator on side of restraint must be entirely in
light blue in rear-facing mode for 0-3 month old, or entirely in blue area for child over 3 months
(diagram 6). A rolled towel may be used to achieve proper recline if needed.
SEE PAGE 2
1
3
4
5 6
2
Important: This information sheet is not a substitute for complete manufacturer’s directions and current recall list. #450 (c)
SafetyBeltSafe U.S.A., 27943 Seco Canyon Rd., Ste 301 Santa Clarita CA 91350 (800) 745-SAFE ©SafetyBeltSafe U.S.A. 3/22
Question and Answer IconNeed help?

Do you have a question about the Graco Contender Slim and is the answer not in the manual?

Graco Contender Slim Specifications

General IconGeneral
Product TypeConvertible Car Seat
Height LimitUp to 49 inches
Weight Capacity (Rear-facing)5-40 lbs
Height Limit (Rear-Facing)Up to 40 inches
InstallationLATCH or Seat Belt
Harness Type5-Point Harness

Summary

Harness System Overview

Harness Slots

Details the eight positions for raising or lowering harness slots.

Crotch Strap

Describes adjustment and proper positioning of the crotch strap.

Angle Adjustment

Explains the recline positions and use of the level indicator.

Installation and Belt Path Guidance

Belt Path Routing

Explains routing the vehicle belt for rear-facing and forward-facing modes.

LATCH System Usage

Details attaching to vehicle lower anchors and weight limits for LATCH.

Tether Strap Functionality

Information on when and how to use the tether strap.

Body Support and Harness Covers

Mentions body support and harness covers for forward-facing use.

1 Important Information

1-A Quick Guide to Your Manual

Overview of manual sections, car seat weight limits, and seating location advice.

1-B Welcome to the Graco Family!

Stresses the importance of proper use for child safety and adherence to manual instructions.

1-C Right Mode of Use

Details the weight and height criteria for rear-facing and forward-facing modes.

1-D Before You Begin

Covers registration, help resources, car seat lifespan, and vehicle seat protection.

1-E Safety Warnings

Presents critical safety information, including warnings about air bags and proper restraint.

2 Features

2-A Car Seat Features

Identifies and labels all parts of the car seat for user reference and understanding.

3 Rear-Facing

3-A Rear-Facing Use

Essential guidelines and requirements for rear-facing installation and use.

3-B Install Rear-Facing with Lower Anchor Attachment

Step-by-step instructions for rear-facing installation using the LATCH system.

3-C Install Rear-Facing with Vehicle Seat Belt

Detailed steps for rear-facing installation using the vehicle seat belt.

4 Forward-Facing

4-A Forward-Facing Use

Outlines the proper use and safety requirements for forward-facing mode.

4-B Install Forward-Facing with LATCH

Step-by-step guide for forward-facing installation with the LATCH system.

4-C Install Forward-Facing with Vehicle Seat Belt

Detailed steps for forward-facing installation using the vehicle seat belt.

5 Securing Child

5-A Securing Child 5-Point Harness

Comprehensive guide on properly securing a child with the 5-point harness.

6 Accessories

6-A Accessories

Information on optional accessories like cup holders and infant supports.

7 Moving the Lower Anchor Attachment

7-A Moving the Lower Anchor Attachment

Instructions for relocating the lower anchor connectors between belt paths.

8 Vehicle Information

8-A Uninstall Lower Anchor Connectors and Tether

Steps for correctly removing the lower anchor connectors and tether strap.

8-B Choosing Vehicle Seat Location

Guidance on selecting the safest and most suitable seating position in the vehicle.

8-C Unsafe Vehicle Seat Locations

Identifies vehicle seating areas that are unsafe for car seat installation.

8-D Vehicle Seat Belts

Details types of vehicle seat belts and their installation methods.

9 Care & Cleaning

9-A Cleaning Seat Pad

Instructions for cleaning the car seat's headrest and main seat pad.

9-B Cleaning Buckle

How to properly clean the car seat buckle to ensure functionality.

9-C Cleaning Harness, Lower Anchor Attachment and Tether

Guidelines for surface washing harness straps and other fabric components.

Related product manuals