80
Sliding Latch Plate and ALR Retractor
A latchplate that slides freely on the belt webbing
and cannot, by itself, hold the belt snug around a car
seat.
Slowly pull the shoulder belt all the way out.
Route the vehicle seat belt through the proper belt
path and buckle it in. Then, as you pull the vehicle
seat belt tight, feed all the slack back into the
retractor.
Grab the sides of the seat at the belt path and slide
the seat side-to-side and front-to-back. The seat
should not move more than 1 inch (2.5 cm).
To Next Page
Loading...
