EasyManua.ls Logo

Graco DreamGlider - Swing Motion Operation; Starting and Stopping the Swing

Graco DreamGlider
44 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
31
WARNING avoid serious injury from falling or
sliding out. Always use seat belt. After fastening buckles, adjust belts to get
a snug fit around your infant.
TO TURN SWING ON:
Press On /Off button or press any speed from 1 to 6. When pressing On/Off
button, it automatically starts with the last speed setting that was selected
before the swing was turned off.
Observe the swinging motion for a minute. It takes time for the
swing to adjust to a setting. Change setting if needed.
A small, quiet baby will swing higher on each setting than a larger, more
active baby.
Your seat may be stopped at any time the motor is running without damaging
the motor. Push swing to restart.
If your swing motor stops operating by itself, a protective device
may have been activated. Turn off motor, wait three minutes, then restart
swing.
TO TURN SWING OFF: Press On /Off button.
4-F Starting Swing (6 Speed)
Activar el columpio (6 velocidades)

Related product manuals