Cleanup
28 3A6342A
a. Disengage Trigger Lock (A).
b. Pull and hold Spray Gun trigger (B).
c. Turn Prime/Spray Valve horizontal
to SPRAY position (C).
d. Turn pressure control to 12 o’ clock
position to begin flushing (D). (For
optimal cleaning performance, the
Pressure Control Knob can be
turned to the FastFlush setting.)
9. Continue flushing until flushing fluid
appears clear.
10. Turn Pressure Control Knob to OFF (all
the way counterclockwise).
11. Stop triggering Spray Gun.
12. Remove Suction Tube from flushing fluid
so that air can enter the pump and push
flushing fluid out of the Hose and Spray
Gun.
13. Trigger Spray Gun into flushing pail and
turn Pressure Control Knob to 12 o’ clock
position to purge fluid from Hose.
14. When flushing fluid has been purged,
release trigger. Engage Trigger Lock.
15. Turn Pressure Control Knob to OFF and
turn ON/OFF switch to OFF position.
Disconnect power to sprayer.
16. Turn Prime/Spray Valve horizontal to
PRIME position.
17. Remove Spray Tip and Spray Tip Guard
from Spray Gun. Remove filter from
Spray Gun. Clean and inspect. Reinstall.
See separate Spray Gun manual for
more information.
To Next Page
Loading...
Need help?
General
