Graco Smart Seat Replacement Guide

To Remove Existing Harness Tongues and Buckle and Attach Replacement Buckle
Smart Seat® Buckle Replacement Guide
©2014 Graco PD272023C 5/14
Remove the chest clip. DO
NOT DISCARD the chest
clip.
5
Lift back cover up and
then rotate back as
shown.
4
Do not remove the
elastic straps at the
top. Remove the back
cover by removing the 2
screws.
2
Loosen straps by lifting
lever and pull harness
straps out.
1
10
Unbuckle harness by
tilting top of buckle
down, press top of red
button, and pull
tongues out of buckle.
Remove seat from base.
3
8
Turn seat upright. Pull
harness straps out from
the seat.
7
Pull harness straps out
from behind the bar
6
Remove the harness strap
loops from splitter plate.
9
MAKE SURE headrest is
not in highest position.
Lay the seat on a table or
ÀRRUZLWKWKHEDFNIDFLQJ
up.
You will receive ONE of
these Graco approved
replacement buckles.
Follow instructions for
proper installation.

Graco Smart Seat Specifications

General

Type	Convertible Car Seat
Recline Positions	Multiple recline positions
Harness System	5-point harness
Rear-facing weight limit	5-40 lbs
Forward-facing weight limit	22-65 lbs
Weight Limit	5-40 lbs rear-facing, 22-65 lbs forward-facing
Safety Features	Side Impact Protection
Installation	LATCH system or seat belt
Additional Features	Removable head and body support