16
Installation without base
DO NOT install this infant carrier
module on vehicle seats with Lap
Belts.
This infant carrier module is suitable
for vehicle seats with a 3-point
Retractor Safety Belt only.
Place the infant carrier module onto
the vehicle seat where you wish to
put it.
Pull the vehicle safety belt out and
lock it into the vehicle buckle, sliding
the vehicle lap belt into the side
guides of the infant carrier module.
Slide diagonal belt into the rear
guide.
The infant carrier module can not be
used if the vehicle safety belt buckle
(female buckle end) is too long to
anchor the infant carrier module
securely.
Pull the vehicle shoulder belt to
fasten the infant carrier module
tightly and securely.
Detaching Seat Pad
see images
To re-assemble the soft goods,
reverse the aforementioned steps.
Care and Maintenance
see images
Please wash the seat cover and inner
padding with cold water under 30°C.
Do not iron the soft goods.
Do not bleach or dry clean the soft
goods.
Do not use undiluted detergents﹐
gasoline or other organic solvent to
wash the infant carrier module. It
may cause damage to the enhanced
child restraint.
Do not twist the seat cover and inner
padding in an attempt to dry. It may
leave the seat cover and inner
padding with wrinkles.
Please hang dry the seat cover and
inner padding in the shade.
Please remove the enhanced child
restraint from the vehicle seat if not
in use for a long period of time. Put
the enhanced child restraint in a cool,
dry place and somewhere your child
cannot access it.
Store instruction manual in the slot
with the instruction book icon as
shown. Replacement Parts To
purchase parts or accessories, please
contact us at the following:
www.gracobaby.eu
www.graco.co.uk
www.gracobaby.pl
26
27
28
29
30
31
32
33
34
35
To Next Page
Loading...
Need help?
General