46
Grab the sides of the seat at the belt
path and slide side to side and front
to back. The base or seat should
not move more than 1” (2.5 cm).
Locking Latch Plate
and No Retractor
When installing the car
seat base, route the lap
seat belt through the
proper path and buckle
it in. Then, pull upwards
on the tail of the belt
so that the lap belt gets
tight around the car seat
base.
Sewn On Latch Plate
and ALR Retractor
Slowly pull the lap belt
all the way out. Route
the vehicle seat lap belt
through the proper belt
path and buckle it in.
Then, pull the lap belt
tight while feeding all
the slack back into the
retractor.
Grab the sides of the seat at the belt
path and slide side to side and front
to back. The base or seat should
not move more than 1” (2.5 cm).
Lap Belt Installation
Always review your vehicle owner’s manual for specific
information about your vehicle seat belts.
To Next Page
Loading...
