16
The „P“ button will stay fully illuminated,
while the button and buttons will
soften in brightness.
Notice: The programming mode can be aborted
at any stage by pressing the „P“ button again.
Select either the or button to program
the grind time for that selected button. The
selected button will begin to ash, and the
grinding will become activated.
Coffee grounds will begin to fall into the
group handle.
To stop the grinding process and set your
programmed or grind amount,
re-select the or button that was
previously selected (this is indicated by
the ashing button). The motor will be de-
activated, and the time of the selected or
function will be stored.
Notice: The grind setting should no longer be
altered, in order not to change the quantity of
coffee grounds. After an alteration of grind set-
ting, the programming has to be repeated.
Allowable program time for and
buttons 2 is sec – 40 sec.
Factory setting
Press „P“ button for 5 seconds. All 3 buttons
will ash.
Cleaning
Old coffee grounds remaining in the appliance
can lead to oxidation. That spoils the beverage;
it can cause an unpleasant, rancid taste.
The appliance should always be in optimum
condition to be able to provide optimum results
at any time.
Ensure the appliance is switched off and
unplugged from the power socket.
Clean the exterior of the appliance with a
soft, moist cloth. If heavily soiled, a mild
detergent can be used.
Take off the coffee bean container. Press it
down and turn counter-clockwise.
Take out the unused beans and put them in an
airtight container so they stay fresh.
To Next Page
Loading...
