EasyManua.ls Logo

Graef WK 80 - Setup and Initial Use; Before First Use; Unpacking and Installation

Graef WK 80
8 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
5
EN
before cleaning.
• Make sure to use the unit only together with
the supplied base station. Never use the base
station for any other purpose.
• Switch the unit on only after you have lled it
with water. Use cold water only.
• The lid of the unit must always be rmly
closed.
• Make sure the unit is switched off and is not
connected to the mains.
• Do not use any aggressive or abrasive clean-
ing agents and do not use any solvents.
• Do not scratch off stubborn soiling with hard
objects.
• Do not rinse the unit off in water or immerse
it into water.
Before the rst use
Read these operating instructions thoroughly
and keep them handy for referral later on.
This unit brings water to boil in a few minutes.
• To clean the unit, rst ll the unit with clear,
cold water and then boil it. Subsequently
pour away the water.
Unpacking
To unpack the unit, proceed as below:
• Take the unit out of the carton.
• Remove all pieces of the packing.
• Remove any possibly extant labels on the unit
(do not remove the rating plate).
Requirements for the installation location
For safe and awless operation of the unit, the
place of location must meet these prerequi-
sites:
• The unit must be set up on a rm, at, lev-
el and non-slip base that has sufcient load
bearing capacity.
• Make sure the unit cannot fall over.
• Select the location so that children cannot
reach the hot surfaces of the unit and cannot
touch the cable.